Sitemap

Amicuk Programming Answers

Another stuck profile :-)

2015-10-11   Views:1

Advertisement

Hi all, My first post on here.  I have noticed a slowdown in my download speeds recently after moving my Home Hub. Previously it was linked to an internal extension upstairs and I was getting around 6 megabit download speeds quite consistently. I dec

Hi all,
My first post on here.  I have noticed a slowdown in my download speeds recently after moving my Home Hub. Previously it was linked to an internal extension upstairs and I was getting around 6 megabit download speeds quite consistently. I decided to move it downstairs and connect it to the master socket, and since then my speeds have been between 1.7 and 1.9 megabits.
I ran a speed test on 19th August and got these results:
Download speed achieved during the test was -1745 Kbps
For your connection, the acceptable range of speeds is 400-2000 Kbps.
Additional Information:
Your DSL Connection Rate :8128 Kbps(DOWN-STREAM), 448 Kbps(UP-STREAM)
IP Profile for your line is - 2000 Kbps
I checked my internal extensions and there is no audible noise or crackling, but just in case I connected the home hub (via the adsl filter) to the test socket and rebooted the hub.  I expected the profile to improve from 2000 Kbps to something much closer to my connection speed, but four days later it is still stubbornly stuck at 2000 Kbps.
A speed test just now gives the following results:
Download speed achieved during the test was - 1928 Kbps
For your connection, the acceptable range of speeds is 400-2000 Kbps.
Additional Information:
Your DSL Connection Rate :8128 Kbps(DOWN-STREAM), 448 Kbps(UP-STREAM)
IP Profile for your line is - 2000 Kbps
The stats from my home hub are as follows:
ADSL line status
Connection information
Line state
Connected
Connection time
4 days, 8:07:58
Downstream
8,128 Kbps
Upstream
448 Kbps
ADSL settings
VPI/VCI
0/38
Type
PPPoA
Modulation
ITU-T G.992.1
Latency type
Fast
Noise margin (Down/Up)
10.8 dB / 21.0 dB
Line attenuation (Down/Up)
11.0 dB / 5.0 dB
Output power (Down/Up)
13.8 dBm / 11.9 dBm
I don't think the downstream noise margin is too high (but disappointingly above 6db) so I would expect better than a 2000 Kbps profile speed. 
Any thoughts on how I can get the profile reset?  I think it is stuck at the moment.
Many thanks,
Mark.
Solved!
Go to Solution.

The replay answer
Advertisement
your noise margin if ok as you have the max speed for adslmax - you have noise margin in hand which is good for when you get upgraded to 21CN
your profile is stuck so email the mods for help  http://bt.custhelp.com/app/contact_email/c/4951
If you like a post, or want to say thanks for a helpful answer, please click on the Ratings star on the left-hand side of the post.
If someone answers your question correctly please let other members know by clicking on ’Mark as Accepted Solution’.

Go to See the other 7 answers

Stuck Profile Part II

Category:DefaultRelease time:-0001-11-30Views:130

Hi. Following on from https://community.bt.com/t5/ADSL-Copper-Broadband-Speed/Stuck-Profile/td-p/1433921/page/3 Here's my problem, my broadband is fast enough and stable at around 10db SNR giving me 13Mbps. But when my connection re-syncs to a lower[More]

Yet another stuck profile?

Category:DefaultRelease time:-0001-11-30Views:130

I think I too have a stuck profile. When I first connected using this modem/router (8 months or so) I was getting between 12 and 15 Mbps. about three months ago it dropped (gradually) down to its present speed. I recently renewed my contract and was[More]

Stuck profile and pretty sick of liars

Category:DefaultRelease time:-0001-11-30Views:130

Ok, after a powercut on Monday (which was widespread in Co Down), my profile is back on the same, pathetic. "up to 2000kps" profile that it ALWAYS goes on if there is even a hint of thunder or a blip in the electric..  Download speedachieved dur[More]

Stuck Profile 2000k

Category:DefaultRelease time:-0001-11-30Views:130

Hi, Been haveing problems with a stuck profile for just over a month now.....Not sure what to do next ....Before my profile got stuck i was getting 6.5 to 7mb from my 8mb connection now i cant get more than 2mb sob.... I've tried all the hints, tips[More]

Another stuck profile :-)

Category:DefaultRelease time:2015-10-11Views:130

Hi all, My first post on here.  I have noticed a slowdown in my download speeds recently after moving my Home Hub. Previously it was linked to an internal extension upstairs and I was getting around 6 megabit download speeds quite consistently. I dec[More]

Line resets and stuck profiles (question not issue...

Category:DefaultRelease time:2015-10-11Views:130

One of the mods in their calls to me mentioned that they are happy to do some line resets for me but want to avoid them too often since this caused the DLM to get concerned over the line status. [I have no reason to doubt this statement] Now in my ca[More]

Stuck Profile Again...

Category:DefaultRelease time:-0001-11-30Views:130

My girlfriend tripped over my modem on Saturday and pulled the powerline out...This ONE ****ing disconection has resulted in a banded/stuck ip profile.... Download speedachieved during the test was - 1803 Kbps  For your connection, the acceptable ran[More]

Stuck "Profile for everyone" with password

Category:DefaultRelease time:-0001-11-30Views:130

Hi there, I have one user who have an old "Profile for Everyone" on his MacBook. I'm not able to remove the the profile, because it has  "PayloadRemovalDisallowed" by password set, and the pwd is not known anymore (the admin has left).[More]

Stuck profile?

Category:DefaultRelease time:-0001-11-30Views:130

Hi Mods. Can anyone see if they can get my line retrained? I spoke to support who advised me it would take upto to 16 days for this to happen. It's now been 21 days and nothing is happening. My router stats are below with the results of my latest spe[More]

Stuck profile - over 5 days

Category:DefaultRelease time:-0001-11-30Views:130

Hi, A couple of weeks ago I moved my home office setup around and unwittingly plonked my router next to a Powerline network adapter on the same 4 gang extension. It would seem this sent my connection into an error spin and I only noticed it had dumpe[More]

Stuck Profile during training?

Category:DefaultRelease time:-0001-11-30Views:130

Hello, I have recently switched to BT broadband from another ISP which used BT Wholesale. My connection has been approx 14Mb for over 2 years without an issue. For the last 4 days my line has been enabled with BT my connection speed has been exactly[More]

Hot
Hi All, Can we use the installment plan in FI-CA for the outgoing payments to business partners. Our company has lot of lease contracts and these contracts have payments due to be paid on a monthly, quarterly, semi-annual, and annual basis. All these [More]
Hello, I recently bought a VISA 3prepaid voucher and now I cannot download anymore apps because the card is out of date and it says "Sign in required" and I don't want to add my Credit card details. Please help me because it has no "NONE&qu [More]
I have been working with cS4 for sometime now. I worked in dreamweaver last night and tried to open a file but it took forever so I tried to force quit  it. Still it was not responding so I shut my computer down and waited for 30 minutes. I tried to [More]
i bourght a digital photo frame recently but am having trouble exportin from my iphoto library. I need to export to the native resolution of the frame which is 480x234 to optimise the number of photos I can fit on the memory card (any larger is just [More]
I`ve made my first motion Project by using a tutorial http://www.izzyvideo.com/motion-animated-map/http://www.izzyvideo.com/motion-animated-map/ I want to use this as a template. Whats the easiest way to change cities and directions? Eventually this [More]
Hi all, I am using ecc6.0 which is integrated with r/3. now I am trying use the standard worflow WS12300111 for it. I configured the leave types in spro - personam management -ess - leave request, and specified the workflow number there. I have relat [More]
Hello, I'm working with a 3D bar graph I've connected a matrix on 3D Bar Datatype.lvclasslotHelper.vi. I've some problems with this graph: - aparently, each row of my matrix is considered as a data: with a 10x7 matrix, my graph has 10 different color [More]
Hi, I have a problem with transporting from DEV to PROD. There are no imports in import queue in SMTS. I can export data from DEV, but there are not displayed in STMS. (Only texts as Language Netweaver 04 SR1 CS). In TMS alert viewer there are a lot [More]
Hi, On the DD-WRT forum, "experts" say to do a 30-30-30 to have a good reset. Others say it's risky because it can brick the router, only a simple hard reset is sufficient. Who's right?Pretty much it's a last ditch effort to get the router to a [More]
when i uesd explorer i could right click on the mouse and hit create short cut to desktop and now it only brings up bookmark when i right click and also the same with cut and paste is not there any more either not when i right click please help me i [More]